How to install your Floorless modular tiles.
Here we will show you the basics on installing your Floorless tiles.
step 1
Preparation
Ensure that the area is clear of any loose debris, dirt and dust. Surface area should be clear of any furniture.
Step 2
Measure
Use a tape measure to find the centre of the garage, mark the centre with pencil or chalk, this will be your guide on where to lay your first tiles.
Step 3
Make a start
Connect two tiles by using the interlocking system; you can use your hands to press this in initially, but you will need a rubber mallet to ensure a tight connection. Place the centre of the two tiles in line with the centre line marked earlier.
Step 4
Start interlocking
We recommend starting from the front of the garage, building width ways firstly, then making your way towards the back, until you reach a point where you will have to make cuts at the back of and the edges of the garage.
Step 5
Cutting
At this stage, you will have equal spacing left on both sides of the garage and to the rear. Measure the distance between the wall and the vented tile. Take the measure and mark on the tile where the cut is needed and ensure this is on the correct side of the tile before cutting – and cut (you can use a handheld saw, but we would recommend a table top saw for a cleaner, more accurate cut).
Please note: measure from tile to tile, as walls may be out slightly.
Step 6
FInal touches
Once the final tiles are down, wipe down with at spray mop, and you have completed your garage flooring installation.